RedWardancer Posted October 20, 2020 Share Posted October 20, 2020 Working on a scenario project (AGAIN?!? JUST STOP RED, YOU SUCK!). I have six BRDM-2 units each with three variable scout paths to use. I made certain the X variables and the values, along with the correct "IF this UNIT is RECON/21" and so on were accurate. The problem is that one or two of these units would remain in place and not move out under orders during testing. The other four or five recon units would roll out as ordered. What's going on here? Here is just a log of my work. I have shown the conditions places on the routes for each of the six recon units as such: Recon 31. Embark if: This is Unit Recon 31 AND 0 <= Random Variable X1 < 40. Embark if: This is Unit Recon 31 AND 40 <= Random Variable X2 <65. Embark if: This is Unit Recon 31 AND 65 <= Random Variable X3 <100. I have noticed after five test runs, three of the same units would pose a problem, but not all at once. So, what's up with that? 0 Quote Link to comment Share on other sites More sharing options...
Rotareneg Posted October 20, 2020 Share Posted October 20, 2020 (edited) It's quite possible for X1 to be 50, X2 95, and X3 9, at which point the vehicle wouldn't take any of those routes. Edited October 20, 2020 by Rotareneg 0 Quote Link to comment Share on other sites More sharing options...
Members Ssnake Posted October 20, 2020 Members Share Posted October 20, 2020 Yes. You're using three different random variables, each of them will have a different value. Use the same variable in each condition, and it'll work. 0 Quote Link to comment Share on other sites More sharing options...
RedWardancer Posted October 20, 2020 Author Share Posted October 20, 2020 Oops. 0 Quote Link to comment Share on other sites More sharing options...
Members Ssnake Posted October 20, 2020 Members Share Posted October 20, 2020 You'll remember the difference even better now. 0 Quote Link to comment Share on other sites More sharing options...
RedWardancer Posted October 20, 2020 Author Share Posted October 20, 2020 (edited) Just now found my old scenario design notes not ten minutes ago. Two full pages of it, could have told me what to do as you have done today. Yep. *Crawls into a hole and hides* 😒 Edited October 20, 2020 by RedWardancer 0 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.